INTAKE MANIFOLD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake manifold removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Replacement of throttle body with motor assembly Cleaning the deposits from the throttle body with motor assembly	Inspection after repair	Poor idle, engine start, etc.	Click here

PROCEDURE

REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Click here
REMOVE FRONT FENDER SEAL LH

Click here
REMOVE PURGE VSV

Click here
REMOVE INTAKE MANIFOLD
1. Detach the 4 wire harness clamps from the 2 wire harness clamp brackets.
2. Detach the No. 1 fuel hose from the intake manifold.
3. for RHD:
  
  Detach the engine wire harness clamp.
4. *A for LHD
  
  *B for RHD
  
  Remove the bolt and disconnect the heater water pipe sub-assembly from the intake manifold.
5. w/ Heater:
  
  Detach the No. 2 water by-pass hose from the intake manifold.
6. Slide the clip and disconnect the No. 3 PCV hose from the intake manifold.
7. Slide the clip and disconnect the union to connector tube hose from the intake manifold.
8. Detach the clamp, and then slide the clip and remove the purge line hose from the intake manifold.
9. Remove the 2 No. 2 intake manifold insulators from the intake manifold.
10. Remove the 5 bolts, 2 nuts and intake manifold.
11. Remove the gasket from the intake manifold.
12. for LHD:
  
  Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.
13. for RHD:
  
  Remove the 3 bolts and 3 wire harness clamp brackets from the intake manifold.
14. Remove the intake manifold insulator from the intake manifold.

*A	for LHD
*B	for RHD