FRONT BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RH and LH sides.
The procedures listed below is for the LH side.

PROCEDURE

INSTALL FRONT NO. 1 WHEEL CYLINDER TUBE LH
1. *a Torque Wrench Fulcrum Length
  
  Using a union nut wrench, install the front No. 1 wheel cylinder tube LH to the disc brake cylinder assembly LH.
  
  Torque:
  
  Specified tightening torque
  
  15.2 N*m { 155 kgf*cm, 11 ft.*lbf }
  Tech Tips
  - Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
    
    Click here
  - When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
  Note
  - Do not bend or damage the front No. 1 wheel cylinder tube LH.
  - Do not allow any foreign matter such as dirt and dust to enter the front No. 1 wheel cylinder tube LH from the connecting points.
INSTALL FRONT FLEXIBLE HOSE
1. Attach 2 new clips to the front flexible hose.
2. *a Torque Wrench Fulcrum Length
  
  Using a union nut wrench, connect the flexible hose to the brake line and front No. 1 wheel cylinder tube LH while holding the front flexible hose with a wrench.
  
  Torque:
  
  Specified tightening torque
  
  15.2 N*m { 155 kgf*cm, 11 ft.*lbf }
  Tech Tips
  - Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
    
    Click here
  - When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
  Note
  - Do not bend or damage the brake line and front No. 1 wheel cylinder tube LH.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line and front No. 1 wheel cylinder tube LH from the connecting points.
BLEED BRAKE LINE

Click here
BLEED CLUTCH LINE (for Manual Transmission)

Click here
INSTALL FRONT WHEEL

Click here