VSC OFF SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  7. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Automatic Transmission)

    Click here

  8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  10. REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

    Click here

  11. REMOVE VSC OFF SWITCH


    1. B003KPFC01
      B003OFB Remove in this Direction

      Disconnect the VSC OFF switch connector.

    2. Detach the 2 claws and remove the VSC OFF switch from the lower instrument cover sub-assembly.