REAR STABILIZER BAR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear stabilizer bar removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation Headlight leveling ECU assembly initialization Headlight leveling function

Click here

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    1. B003PH8

      Remove the 2 nuts and rear stabilizer link assembly LH.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.

  3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. REMOVE REAR STABILIZER BRACKET COVER


    1. B003LU4

      Remove the 2 bolts, 2 nuts and 2 rear stabilizer bracket covers.

  5. REMOVE REAR STABILIZER BUSH


    1. Remove the 2 rear stabilizer bushes.

  6. REMOVE REAR STABILIZER BAR


    1. Remove the rear stabilizer bar.