REAR DIFFERENTIAL LOCK POSITION SWITCH(for DANA Made w/ Differential Lock) INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Click here

  2. INSTALL WIRING HARNESS CLAMP BRACKET


    1. Install the wiring harness clamp bracket with the bolt.

      Torque:
      29.5 N*m  { 301 kgf*cm, 22 ft.*lbf }
    2. B003L5R

      Attach the 2 clamps.

    3. Connect the 3 connectors.

  3. INSTALL REAR DIFFERENTIAL PROTECTOR


    1. Install the differential protector with the 2 bolts.

      Torque:
      29.5 N*m  { 301 kgf*cm, 22 ft.*lbf }

  4. INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

    Click here

  5. INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. INSTALL REAR PROPELLER SHAFT ASSEMBLY

    Click here

  7. ADD DIFFERENTIAL OIL

    Click here

  8. BLEED AIR FROM BRAKE LINE


    1. w/ VSC:

      Click here

    2. w/o VSC:

      Click here

  9. ADJUST PARKING BRAKE

    Click here

  10. INSTALL REAR WHEEL

    Click here

  11. CHECK ABS SPEED SENSOR SIGNAL


    1. w/ VSC:

      Click here

    2. w/o VSC:

      Click here