FUEL PUMP REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pump removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of fuel pump Inspection after repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. REMOVE FUEL TANK ASSEMBLY

    Click here

  2. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. B003QZX

      Remove the 2 tube joint clips and pull out the fuel tank main tube sub-assembly and fuel tank return tube from the fuel suction with pump and gauge tube assembly.

      Note

      B003OMBC11
      *a Fuel Tube Joint
      *b Fuel Tube
      *c O-Ring
      *d Tube Joint Clip

      • Remove any dirt and foreign matter on the fuel tube joint before performing this work.

      • Do not allow any scratches or foreign matter on the parts when disconnecting them, as the fuel tube joint contains the O-rings that seal the plug.

      • Perform this work by hand. Do not use any tools.

      • Do not forcibly bend or twist the nylon tube.

      • Protect the disconnected parts by covering them with plastic bags and tape after disconnecting the fuel tank main tube sub-assembly and fuel tank return tube.

    2. Remove the fuel pump gauge retainer from the fuel tank assembly.


      1. B003LRQC02
        *a SST (Plate)
        *b SST (Claw)
        *c Insertion Point
        B003R2S SST (Bolt)

        Set the 2 clamps, 2 bolts and plate of SST on the fuel pump gauge retainer.

        SST
        09808-14031   ( 09808-01010, 09808-01020, 09808-01030, 09808-01090 )
        09808-01071

        Tech Tips

        Securely insert the ends of SST into the insertion points in the fuel pump gauge retainer.

      2. While firmly pressing the claws of SST into the insertion points in the fuel pump gauge retainer, tighten the bolts of the claws.

      3. B003PFYC02
        *a Insertion point

        Attach the handle of SST.

      4. Check once more that the tip of SST is securely inserted into the insertion area of the fuel pump gauge retainer as shown in the illustration.

      5. While lightly pressing down on SST so it does not come off the fuel pump gauge retainer, slowly turn the handle and remove the fuel pump gauge retainer.

        Note


        • Do not use any tools other than SST, such as a screwdriver, etc.

        • Do not use excessive force when pressing down on SST, as the fuel pump gauge retainer will place excessive force on the fuel suction with pump and gauge tube assembly and fuel pump gauge retainer and be difficult to remove, and parts may be damaged.

        • Be sure to keep the handle level when turning it, as SST may slip off the retainer if the handle is turned at an angle with excessive force.

        • Do not use an impact wrench or turn the handle with excessive force, as parts may be damaged.

        • If SST slips off the retainer, loosen the bolts and reattach SST to the retainer.

    3. Remove the fuel suction with pump and gauge tube assembly from the fuel tank assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    4. B003MKN

      Remove the fuel suction tube set gasket from the fuel tank assembly.