REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. B003K03E03

      Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the rear engine oil seal is properly installed.

  2. INSTALL FLYWHEEL HOUSING DUST SEAL

  3. INSTALL REAR END PLATE

    Click here

  4. INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  5. INSTALL CLUTCH DISC ASSEMBLY

    Click here

  6. INSTALL CLUTCH COVER ASSEMBLY

    Click here

  7. INSTALL MANUAL TRANSMISSION ASSEMBLY

    Click here