EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. B003QHT

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum length
      40 mm (1.57 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. B003RMXC01
      *1 Gasket
      *2 Turbine Outlet Elbow

      Install a new gasket to the turbine outlet elbow.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.

    3. B003MKMC38
      *1 Gasket
      *a Wooden Block

      Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the turbine outlet elbow.

    4. Install the front exhaust pipe and 2 compression springs with the 2 bolts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. Install the center exhaust pipe assembly to the 3 exhaust pipe supports.

    2. Install a new gasket and connect the center exhaust pipe to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      Note

      Do not reuse the gasket.

  3. INSTALL TAILPIPE ASSEMBLY


    1. Install the tailpipe assembly to the 4 exhaust pipe supports.

    2. Install a new gasket and connect the tailpipe assembly to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      Note

      Do not reuse the gasket.

  4. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the problem areas to stop the leak. Replace damaged parts as necessary.