DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT

    Tech Tips

    When reusing the fan and generator V belt, check the circumference for wear or cracked back and ribs. Replace any belts with wear or cracked ribs that have reached the core (at 1 point or more) and belts with missing rubber ribs (at 1 point or more).


    1. B003RW0C01
      *1 Vane Pump Assembly
      *2 Engine Water Pump Assembly
      *3 No. 2 Idler Pulley
      *4 Generator Assembly
      *5 Cooler Compressor Assembly
      *6 No. 1 Idler Pulley
      *7 Crankshaft Pulley
      *8 V-ribbed Belt Tensioner Assembly

      Set the fan and generator V belt onto each part.

    2. While turning the belt tensioner counterclockwise, remove the bar.

      Note

      Make sure that the fan and generator V belt is properly installed to each pulley.

    3. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.