CRANKSHAFT POSITION SENSOR REMOVAL

PROCEDURE


  1. REMOVE FAN AND GENERATOR V BELT

    Click here

  2. REMOVE FRONT UPPER FENDER APRON SEAL LH

    Click here

  3. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    1. B003M2R

      Remove the bolt and disconnect the suction hose sub-assembly from the engine.

    2. B003M56

      Disconnect the cooler compressor connector.

    3. Remove the 2 bolts and 2 nuts.

    4. B003S05

      Using an E8 "TORX" socket wrench, remove the 2 stud bolts and disconnect the cooler compressor assembly.

    5. Support the cooler compressor assembly securely.

      Tech Tips

      It is not necessary to completely remove the cooler compressor assembly. With the hoses connected to the cooler compressor assembly, hang the cooler compressor assembly on the vehicle body with a rope.

  4. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

    Click here

  5. REMOVE CRANKSHAFT POSITION SENSOR


    1. B003RGX

      Disconnect the crankshaft position sensor connector.

    2. Disconnect the crankshaft position sensor connector from the connector bracket.

    3. Detach the harness clamp.

    4. Remove the bolt and crankshaft position sensor.