CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. Install the crankshaft position sensor with the bolt to the rear oil seal retainer.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • When reusing the crankshaft position sensor, check the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing to the rear oil seal retainer.

      • Replace with a new part if it is dropped or if it receives a strong impact.

  2. INSTALL CRANKSHAFT POSITION SENSOR HARNESS BRACKET


    1. Install the crankshaft position sensor harness bracket with the bolt to the cylinder block sub-assembly.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL CONNECTING WIRE


    1. Connect the 2 connectors and clamp and install the connecting wire.

  4. INSTALL NO. 5 CYLINDER BLOCK INSULATOR

    Click here

  5. INSTALL NO. 1 CYLINDER BLOCK INSULATOR

    Click here

  6. INSTALL REAR END PLATE

    Click here

  7. INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  8. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  9. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  10. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)


  11. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

    Click here