AIR FUEL RATIO SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of air fuel ratio sensor Clear A/F Sensor Compensation data -

Click here

CAUTION:


  • B003QNZ

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

  • B003QLO

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

PROCEDURE


  1. REMOVE FRONT FENDER SEAL RH


    1. Remove the 6 clips and front fender seal RH.

  2. REMOVE AIR FUEL RATIO SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. B003OE1N01

      Disconnect the connector and clamp.

    2. Using SST, remove the air fuel ratio sensor.

      SST
      09224-00011