FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL FRONT CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new front crankshaft oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B003P8LC01
      *1 Front Crankshaft Oil Seal
      *2 Timing Chain Cover Assembly
      *a 0 to 1.5 mm (0 to 0.0591 in.)

      Using SST and a hammer, tap in the front crankshaft oil seal.

      SST
      09214-76011

      Note


      • The acceptable depth from the top of the timing chain cover assembly is 0 to 1.5 mm (0 to 0.0591 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the front crankshaft oil seal at an angle.

      • Make sure that the front crankshaft oil seal is properly installed.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the keyway of the crankshaft pulley with the key located on the crankshaft, and then slide the crankshaft pulley into place to install it.

    2. B003SE6N01

      Using SST, install a new pulley bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
      Torque:
      365 N*m  { 3722 kgf*cm, 269 ft.*lbf }

  3. INSTALL CRANKSHAFT PULLEY COVER


    1. w/o Viscous Heater:

      Install the crankshaft pulley cover to the crankshaft pulley with the 4 bolts.

      Torque:
      24.5 N*m  { 250 kgf*cm, 18 ft.*lbf }

    2. w/ Viscous Heater:

      Install the crankshaft pulley cover to the crankshaft pulley.

  4. INSTALL VISCOUS HEATER CRANKSHAFT PULLEY (w/ Viscous Heater)


    1. Install the viscous heater crankshaft pulley to the crankshaft pulley with the 4 bolts.

      Torque:
      24.5 N*m  { 250 kgf*cm, 18 ft.*lbf }

  5. INSTALL RADIATOR ASSEMBLY

    Click here