HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc.

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B003LL1

PROCEDURE


  1. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)

    Click here

  2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    1. B003OT8

      Disconnect the connector.

    2. Detach the 2 clamps.

    3. B003K79N01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe.

      SST
      09224-00011

      Note

      Do not damage the heated oxygen sensor.

  3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    1. B003RY4

      Disconnect the connector.

    2. Detach the 2 clamps.

    3. B003ONIN01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe.

      SST
      09224-00011

      Note

      Do not damage the heated oxygen sensor.