ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ РЕГУЛИРОВКА

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      A01LCYA

  2. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  3. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01L8V6C02
      B0028XU Disconnect in this Direction

      Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.

    3. A01LB4IC01
      *1 Lock Piece
      *a Side View
      *b Bottom View
      *c Push

      Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

    4. A01LA7WC02
      *1 Lock Piece
      B0028XU Connect in this Direction

      Connect the end of the transmission control cable assembly to the transmission floor shift assembly.

      Note


      • The shift lever should be in N.

      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the transmission floor shift assembly pin.

    5. A01LDPQC01
      *1 Lock Piece
      *2 Adjuster Case
      *a Push

      Push the lock piece into the adjuster case.

      Note


      • Check that the park/neutral position switch assembly and shift lever are in neutral.

      • Securely push in the lock piece until it locks.

    6. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

  4. INSTALL CONSOLE BOX ASSEMBLY

    Click here