СТАРТЕР (кроме моделей мощностью 2,0 кВт) УСТАНОВКА

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. for Manual Transmission:

      
      

      1. Temporarily install the starter assembly with the bolt.

      2. Temporarily install the clutch flexible bracket with the bolt.

      3. Tighten the 2 bolts.

         Torque:

         37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. for Automatic Transmission:

      
      

      1. Install the starter assembly with the 2 bolts.

         Torque:

         37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   3. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Connect the terminal cap.

   5. Connect the starter connector.

2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

   Click here

3. INSTALL FRONT FENDER SEAL LH

   
   

   1. for 2WD:

      Install the front fender seal LH with 5 new clips.

   2. for 4WD:

      Install the front fender seal LH with 6 new clips.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here