СТАРТЕР (для моделей мощностью 2,0 кВт) УСТАНОВКА

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Temporarily install the starter assembly and ground cable with the bolt.

   2. Temporarily install the clutch flexible hose bracket with the bolt.

   3. Tighten the 2 bolts.

      Torque:

      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

   4. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   5. Connect the starter connector.

   6. Install the starter terminal cap.

2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

   Click here

3. INSTALL FRONT FENDER SEAL LH

   
   

   1. for 4WD and Pre-Runner:

      Install the front fender seal LH with new 6 clips.

   2. for 2WD:

      Install the front fender seal LH with new 5 clips.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here