СТАРТЕР РАЗБОРКА

PROCEDURE


  1. REMOVE STARTER YOKE ASSEMBLY


    1. A01L94X

      Remove the nut and disconnect the lead wire from the terminal C.

    2. Remove the 2 bolts.

    3. Pull out the starter yoke and starter commutator end frame together with the starter armature.

    4. Remove the O-ring from the starter yoke assembly.

  2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A01L8VA

      Remove the 2 screws and magnet starter switch assembly.

    2. A01LEXGC01
      *1 Idle Gear
      *2 Retainer
      *3 Clutch Roller
      *4 Return Spring
      *5 Starter Clutch Sub-assembly
      *6 Starter Drive Housing Assembly

      Remove the idle gear, retainer, clutch roller, return spring and starter clutch sub-assembly from the starter drive housing assembly.

    3. A01SBHQC12
      *a Magnet Hand

      Using a magnet hand, remove the steel ball from the starter clutch hole.

  3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    1. A01LGE4

      Remove the 2 screws and starter commutator end frame assembly from the starter yoke assembly.

      Note

      While holding down the lead wire, remove the starter commutator end frame assembly.

    2. Remove the O-ring from the starter yoke. assembly

    3. A01LAHK

      Disconnect the 4 brushes from the starter brush holder assembly.


      1. Using a screwdriver, hold back the spring.

      2. Disconnect the brush from the starter brush holder assembly.

    4. Remove the starter brush holder assembly.

  4. REMOVE STARTER ARMATURE ASSEMBLY


    1. Remove the starter armature assembly from the starter yoke assembly.