КОНТАКТНЫЙ ДАТЧИК ДАВЛЕНИЯ МАСЛА УСТАНОВКА

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   
   

   1. Remove any oil from the threads of the engine oil pressure switch assembly.

   2. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

   3. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:

      14.7 N*m  { 150 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

   4. Connect the engine oil pressure switch assembly connector.

2. INSPECT FOR OIL LEAK

   Click here

3. CHECK ENGINE OIL LEVEL

   Click here

4. INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

   Click here

5. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

   Click here