ВЫПУСКНАЯ ТРУБА УСТАНОВКА

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Install the front exhaust pipe assembly to the No. 1 exhaust pipe support.

    2. Install a new gasket.

      Note

      Do not reuse the gaskets.

    3. Connect the front exhaust pipe assembly to the exhaust manifold sub-assembly RH with the 2 new nuts.

      Torque:
      54.3 N*m  { 554 kgf*cm, 40 ft.*lbf }

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    Click here

  3. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

    Click here

  4. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    1. Install the front No. 2 exhaust pipe assembly to the No. 1 exhaust pipe support.

    2. Install 2 new gaskets.

      Note

      Do not reuse the gaskets.

    3. Connect the front No. 2 exhaust pipe assembly to the exhaust manifold sub-assembly LH with the 2 new nuts.

      Torque:
      54.3 N*m  { 554 kgf*cm, 40 ft.*lbf }

    4. Connect the front No. 2 exhaust pipe assembly to the front exhaust pipe assembly with the 2 bolts and 2 new nuts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }
    5. A01SIV2

      Connect the heated oxygen sensor connector.

    6. Attach the 2 clamps.

  5. INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. B0028KV

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum length
      40 mm (1.57 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. Using a wire brush, remove any foreign matter from the gasket installation surface.

    3. B0024QPC38
      *1 Gasket
      *a Wooden Block

      Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with front exhaust pipe assembly.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the tail exhaust pipe assembly, do not push in the gasket with the tail exhaust pipe assembly.

    4. Install the tail exhaust pipe assembly to the 3 No. 1 exhaust pipe supports and No. 2 exhaust pipe support.

    5. Connect the tail exhaust pipe assembly to the front exhaust pipe assembly with the 2 compression spring and 2 bolts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSPECT FOR EXHAUST GAS LEAK

    Click here