ТОПЛИВНЫЙ НАСОС (для моделей с короткой колесной базой) ПОВТОРНАЯ СБОРКА

CAUTION / NOTICE / HINT

Note

Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly.

Click here

PROCEDURE


  1. INSTALL FUEL PUMP

    Tech Tips

    Perform "Inspection After Repair" after replacing the fuel pump.

    Click here


    1. A01LASW

      Install the fuel pump harness and connect the fuel pump connector.

    2. Apply a light coat of gasoline to a new O-ring.

    3. A01LBRKC01
      *1 O-Ring
      *2 Spacer
      *a Supporter

      Install the O-ring and spacer to the supporter of the fuel pump as shown in the illustration.

    4. A01LEEG

      Attach the 3 claws to the claw holes and connect the fuel pump.

  2. INSTALL NO. 1 FUEL SUB-TANK


    1. A01LAUH

      Attach the 2 claws to the claw holes and install the No. 1 fuel sub-tank.

    2. A01LAM0

      Attach the 3 claws to the claw holes.

    3. A01LC58

      Connect the 2 fuel tubes and wire harness.

    4. A01LC53

      Attach the claw on the end of the tube to the claw hole. Connect the tube to the 2 clamps on the No. 1 fuel sub-tank.

    5. A01LFZ6

      Connect the fuel pump connector and wire harness.

  3. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here