ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. A01SBZDN01

      Apply a light coat of MP grease to the lip of a new rear engine oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the rear engine oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A01SD70C01
      *a Hold

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021

    2. Clean the bolts and bolt holes.

    3. Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    4. A01SEWRE01

      Install the flywheel sub-assembly with the 10 new bolts and uniformly tighten the bolts in several steps in the sequence shown in the illustration.

      Torque:
      26.5 N*m  { 270 kgf*cm, 20 ft.*lbf }

    5. Mark the top of the bolts with paint.

    6. Tighten the 10 bolts 90° in the same sequence.

    7. Check that the paint marks are now at a 90° angle to the top.

  3. INSTALL CLUTCH DISC ASSEMBLY

    Click here

  4. INSTALL CLUTCH COVER ASSEMBLY

    Click here

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

    Click here

  6. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

    Click here