ДВИГАТЕЛЬ В СБОРЕ УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *A | w/o Air Conditioning System | - | - |
| *1 | HOOD SUB-ASSEMBLY | *2 | WASHER HOSE |
| *3 | INTAKE PIPE ASSEMBLY | *4 | VANE PUMP OIL RESERVOIR ASSEMBLY |
| *5 | OIL RESERVOIR BRACKET | *6 | RADIATOR RESERVE TANK ASSEMBLY |
| *7 | FAN SHROUD | *8 | RADIATOR ASSEMBLY |
| *9 | NO. 1 RADIATOR HOSE | *10 | NO. 2 RADIATOR HOSE |
| *11 | FLUID COUPLING ASSEMBLY | *12 | FAN PULLEY |
| *13 | VANE PUMP V BELT | *14 | COOLER COMPRESSOR V BELT |
| *15 | FAN AND GENERATOR V BELT | *16 | NO. 1 ENGINE UNDER COVER ASSEMBLY |
| *17 | NO. 2 ENGINE UNDER COVER | *18 | RADIATOR PROTECTOR |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | ENGINE WIRE | *2 | ECM |
| *3 | GLOVE COMPARTMENT DOOR ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BATTERY | *2 | BATTERY CLAMP SUB-ASSEMBLY |
| *3 | BATTERY TRAY | *4 | NO. 1 RELAY BLOCK UPPER COVER |
| *5 | NO. 1 RELAY BLOCK COVER | *6 | WIRE TO WIRE |
| *7 | NO. 2 ENGINE WIRE | *8 | ENGINE ROOM MAIN WIRE |
| *9 | ENGINE WIRE | *10 | HEATER WATER HOSE ASSEMBLY |
| *11 | FUEL HOSE | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/ Air Conditioning System | - | - |
| *1 | AIR CLEANER CAP AND HOSE | *2 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| *3 | AIR CLEANER CASE SUB-ASSEMBLY | *4 | COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH |
| *5 | GENERATOR ASSEMBLY | *6 | VACUUM HOSE |
| *7 | VACUUM PUMP OIL INLET HOSE | *8 | VACUUM PUMP OIL OUTLET HOSE |
| *9 | TERMINAL CAP | *10 | VANE PUMP ASSEMBLY |
| *11 | VANE PUMP DRIVE PULLEY | *12 | GASKET |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *1 | PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY | *2 | FRONT PROPELLER SHAFT ASSEMBLY |
| *3 | PROPELLER SHAFT GUARD | *4 | TRANSFER CASE PROTECTOR LOWER |
| *5 | FRONT EXHAUST PIPE ASSEMBLY | *6 | NO. 1 EXHAUST PIPE SUPPORT BRACKET |
| *7 | COMPRESSION SPRING | *8 | CLAMP |
| *9 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *1 | FRONT AXLE HUB GREASE CAP LH | *2 | FRONT AXLE SHAFT NUT LH |
| *3 | FRONT DRIVE SHAFT ASSEMBLY LH | *4 | FRONT DRIVE SHAFT HOLE SNAP RING |
| *5 | FRONT LOWER NO. 1 SUSPENSION ARM ASSEMBLY LH | *6 | FRONT SPEED SENSOR LH |
| *7 | TIE ROD END SUB-ASSEMBLY LH | *8 | LOCK CAP |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Differential oil |  |
MP grease |
| |
Do not apply lubricants to the threaded parts | - | - |
ILLUSTRATION
| *1 | POWER STEERING LINK ASSEMBLY | *2 | STEERING SLIDING YOKE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | SHIFT LEVER KNOB SUB-ASSEMBLY | *2 | UPPER CONSOLE PANEL SUB-ASSEMBLY |
ILLUSTRATION
| *1 | MANUAL TRANSMISSION UNIT ASSEMBLY | *2 | SHIFT LEVER BOOT ASSEMBLY |
| *3 | SHIFT LEVER ASSEMBLY | *4 | STIFFENER PLATE |
| *5 | STARTER ASSEMBLY | *6 | CLUTCH RELEASE CYLINDER ASSEMBLY |
| *7 | REAR ENGINE MOUNTING INSULATOR | *8 | NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
| *9 | GROUND CABLE | *10 | WIRE HARNESS |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | NO. 2 ENGINE HANGER | *2 | FRONT ENGINE MOUNTING INSULATOR |
| *3 | CLUTCH COVER ASSEMBLY | *4 | CLUTCH DISC ASSEMBLY |
| *5 | FLYWHEEL SUB-ASSEMBLY | *6 | REAR END PLATE |
| *7 | FLYWHEEL HOUSING DUST SEAL | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |