ПРИВОДНОЙ РЕМЕНЬ ГАЗОРАСПРЕДЕЛЕНИЯ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the camshaft sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of injector assembly

  • Injector compensation code registration

  • Pilot quantity learning

 Engine starting

Click here

Replacement of timing belt Mode reset operation

  • Does not illuminate when replacement is necessary

  • Illuminates when replacement is not necessary

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

B0026TA

Note


  • When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

    Replaced Parts (A) Pipes Requiring New Replacement

    • Injector assembly (including shuffling the injector assemblies between the cylinders)

    • Common rail assembly

    • Cylinder head sub-assembly

    • No. 1 injection pipe sub-assembly

    • No. 2 injection pipe sub-assembly

    • No. 3 injection pipe sub-assembly

    • No. 4 injection pipe sub-assembly

    • Supply pump assembly

    • Common rail assembly

    • Cylinder block sub-assembly

    • Cylinder head sub-assembly

    • Cylinder head gasket

    • Timing Gear Case Assembly

    		 Fuel inlet pipe sub-assembly

  • After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 1 RADIATOR HOSE

    Click here

  3. REMOVE FAN SHROUD

    Click here

  4. REMOVE NO. 1 TIMING BELT COVER


    1. B0025WB

      Remove the 6 bolts, 6 washers and No. 1 timing belt cover from the No. 2 timing belt cover and timing gear cover.

  5. REMOVE TIMING BELT


    1. B002881C01
      *a Timing Mark

      Turn the crankshaft clockwise and align the timing marks as shown in the illustration.

      Tech Tips

      If reusing the timing belt, place matchmarks on the timing belt so that it can be installed exactly as before.

    2. B0026M3

      Uniformly loosen and remove the 2 bolts and No. 1 timing belt tensioner assembly from the timing gear cover.

    3. Remove the timing belt.

      Tech Tips

      B002956N01

      • If turning the camshaft sub-assembly while the timing belt is removed, turn the crankshaft 90° counterclockwise as shown in the illustration.

      • When installing the timing belt, turn the camshaft sub-assembly to align the timing marks, and then turn the crankshaft clockwise to align the timing marks.

  6. REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

    Note

    When inspecting the No. 1 timing belt idler sub-assembly, do not remove it unless absolutely necessary.


    1. Using a 10 mm hexagon wrench, remove the timing belt idler shaft, No. 1 timing belt idler sub-assembly and timing belt idler spacer from the timing gear cover.