ПОДОГРЕВАЕМЫЙ КИСЛОРОДНЫЙ ДАТЧИК СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc.

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B002969

PROCEDURE


  1. REMOVE HEATED OXYGEN SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01LBRP

      Disconnect the heated oxygen sensor connector.

    2. Detach the sensor wire from the 4 clamps.

    3. A01L92QN01

      Using SST, remove the heated oxygen sensor.

      SST
      09224-00011