ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

  2. REMOVE FAN AND GENERATOR V BELT

    Click here

  3. REMOVE FRONT UPPER FENDER APRON SEAL LH

    Click here

  4. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    1. A01SCLO

      Remove the bolt and disconnect the suction hose sub-assembly from the timing chain cover sub-assembly.

    2. A01SERQ

      Disconnect the cooler compressor connector.

    3. Remove the 2 bolts and 2 nuts.

    4. A01SD3D

      Using an E8 "TORX" socket wrench, remove the 2 stud bolts and disconnect the cooler compressor assembly.

    5. Support the cooler compressor assembly securely.

      Tech Tips

      It is not necessary to completely remove the cooler compressor assembly. With the hoses connected to the cooler compressor assembly, hang the cooler compressor assembly on the vehicle body with a rope.

  5. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

    Click here

  6. REMOVE CRANKSHAFT POSITION SENSOR


    1. A01SEO8

      Disconnect the crankshaft position sensor connector.

    2. Disconnect the crankshaft position sensor connector from the connector bracket.

    3. Detach the harness clamp.

    4. Remove the bolt and crankshaft position sensor.