ДАТЧИК МАССОВОГО РАСХОДА ВОЗДУХА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. CHECK INTAKE MASS AIR FLOW METER SUB-ASSEMBLY


    1. Read the value using the GTS (MAF).

      Note

      Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


      1. Connect the GTS to the DLC3.

      2. Start the engine.

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Engine / Data List / MAF.


        Powertrain > Engine > Data List
        Tester Display
        MAF

      5. Wait 30 seconds, and then read the value on the GTS.

        Standard Condition
        GTS Display Condition Specified Condition
        MAF Idling 1.0 to 5.0 gm/sec
        2000 rpm 5.0 to 9.0 gm/sec
        3000 rpm 9.0 to 15.0 gm/sec

        If the result is not as specified, replace the intake mass air flow meter sub-assembly.

        If the result is within the specified range, inspect the intake mass air flow meter sub-assembly.

        Click here