ECM СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM Vehicle Identification Number (VIN) registration DTC P0630 is output

Click here

Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE


  1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  2. REMOVE ECM


    1. Disconnect the 4 connectors.

    2. for LHD:

      Detach the 2 clamps.

    3. for RHD:

      Detach the 3 clamps.

    4. B0028HTC02
      *A for LHD
      *B for RHD

      Remove the bolt, 2 nuts and ECM.

  3. REMOVE NO. 1 ECM BRACKET


    1. B0027DJC02
      *A for LHD
      *B for RHD

      Remove the 2 screws and No. 1 ECM bracket.

  4. REMOVE NO. 2 ECM BRACKET


    1. B0028ODC02
      *A for LHD
      *B for RHD

      Remove the 2 screws and No. 2 ECM bracket.