РЕЛЕ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. INSPECT STARTER RELAY (ST)


    1. B002968

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT GLOW PLUG RELAY (GLOW)


    1. B002968

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the glow plug relay.

  3. INSPECT IG2 RELAY (IG2)


    1. B0026S9E05

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the IG2 relay.

  4. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

    B00278FC01
    *a

    Component without harness connected

    (Instrument Panel Junction Block Assembly)

    		 - -

    Note

    Before performing the relay inspections for the relays of the instrument panel junction block assembly, inspect the EFI-MAIN NO. 1 fuse.


    1. Remove the instrument panel junction block assembly.

      Click here

    2. Remove the body ECU from the instrument panel junction block assembly.

      Click here

    3. Inspect the EFI-MAIN NO. 1 relay.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2B-1 - 2G-5 Battery voltage not applied to terminals 2P-9 and 2J-5 10 kΩ or higher
        Battery voltage applied to terminals 2P-9 and 2J-5 Below 1 Ω

        If the result is not as specified, replace the instrument panel junction block assembly.

    4. Install the body ECU to the instrument panel junction block assembly.

      Click here

    5. Install the instrument panel junction block assembly.

      Click here