| DTC Code | DTC Name |
|---|---|
| P0607 | Control Module Performance |
| P1611 | ECM/PCM Processor / Run Pulse |
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0607 | Control Module Performance | ECM internal error (1 trip detection logic) |
ECM | Comes on | DTC stored |
| P1611 | IC Circuit Malfunction | ECM internal error (1 trip detection logic) |
ECM | Comes on | DTC stored |
CONFIRMATION DRIVING PATTERN
| DTC Detection Drive Pattern | Ignition switch to ON for 1 second |
CAUTION / NOTICE / HINT
Note
After replacing the ECM, the new ECM needs registration (See page ) and initialization Click here.
Tech Tips
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
PROCEDURE
CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0607 AND/OR P1611)
Connect an GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
GO TO DTC CHART Click here |
| A |
|
REPLACE ECM
Replace the ECM.
| Result | ||
|---|---|---|
|
| NEXT |
|
CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
Connect the GTS to the DLC3.
Clear the DTCs.
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Result | ||
|---|---|---|
|
| NEXT |
|
END |