ПЕРЕДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE


  1. INSTALL FRONT CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new front crankshaft oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B0024BMN01

      Using SST and a hammer, tap in the front crankshaft oil seal.

      SST
      09214-76011

      Note


      • The acceptable depth from the top of the timing chain cover is 0 to 1.0 mm (0 to 0.0394 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the front crankshaft oil seal at an angle.

      • Make sure that the front crankshaft oil seal is properly installed.

  2. INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY


    1. Align the keyway of the crankshaft pulley with the key located on the crankshaft, and then slide the crankshaft pulley sub-assembly into place to install it.

    2. B0028KGC01
      *a Hold
      B0027PX Turn

      Using SST, install the crankshaft pulley bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
      Torque:
      365 N*m  { 3722 kgf*cm, 269 ft.*lbf }

  3. INSTALL RADIATOR ASSEMBLY

    Click here