ДАТЧИК МАССОВОГО РАСХОДА ВОЗДУХА СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of intake mass air flow meter sub-assembly Inspection After Repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MASS AIR FLOW METER SUB-ASSEMBLY


    1. A01LEVP

      Disconnect the intake mass air flow meter connector.

    2. Remove the 2 screws and intake mass air flow meter sub-assembly.

    3. Remove the O-ring from the intake mass air flow meter sub-assembly.