КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection After Repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE


    1. A01SD6W

      Detach the 2 clamps and disconnect the intake mass air flow meter connector.

    2. A01SB55

      Disconnect the vacuum hose from the No. 1 air cleaner hose.

    3. Slide the clamp and disconnect the No. 2 ventilation hose from the No. 1 air cleaner hose.

    4. A01SAXI

      Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle body with motor assembly.

    5. Detach the 4 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01SC4O

      Slide the 2 hose clamps and disconnect the No. 4 water by-pass hose and No. 5 water by-pass hose.

    2. A01SDUU

      Disconnect the throttle body with motor connector.

    3. Remove the 4 bolts and throttle body with motor assembly.

    4. Remove the gasket from the intake air surge tank.