ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

    Click here

  2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the engine coolant temperature sensor connector.

    2. A01L9X3N01

      Using SST, remove the engine coolant temperature sensor.

      SST
      09817-33191

    3. Remove the gasket from the engine coolant temperature sensor.