BACK DOOR OUTSIDE GARNISH(for ALPHARD) INSTALLATION

PROCEDURE


  1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. A01IHZ2C02
      *1 Back Window Outside Moulding
      B006PCE Masking Tape

      Secure the back window outside moulding to the glass surface with masking tape as shown in the illustration.

    2. A01IGEP

      Attach the clip to install the back door outside garnish sub-assembly.

      Note

      Make sure that the back window outside moulding is not pinched by the back door outside garnish sub-assembly.

    3. Remove the masking tape.

    4. Install the 4 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  3. INSTALL SWITCH BEZEL (w/ Power Back Door)

    Click here

  4. INSTALL BACK DOOR INSIDE HANDLE

    Click here

  5. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  6. INSTALL BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)

    Click here

  7. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

  8. INSTALL CENTER BACK DOOR GARNISH

    Click here