REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door belt moulding removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here


  • Rear door glass sub-assembly

  • Rear door glass run

 Initialize Power Window Control System

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • When removing the rear door glass sub-assembly LH, move the rear door glass sub-assembly LH to the lowest position before disconnecting the negative (-) battery terminal.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B006LHC

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 3 SLIDE DOOR WEATHERSTRIP LH

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  5. REMOVE SLIDE DOOR WINDOW GARNISH LH

    Click here

  6. REMOVE REAR DOOR FRONT WINDOW GUIDE LH

    Click here

  7. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP WITH GARNISH

    Click here

  8. REMOVE SLIDE DOOR HANDLE ASSEMBLY LH

    Click here

  9. REMOVE NO. 2 SLIDE DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE REAR DOOR GLASS RUN LH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING LH

    Click here

  13. REMOVE REAR DOOR REAR WINDOW FRAME MOULDING LH

    Click here

  14. REMOVE REAR DOOR BELT MOULDING LH


    1. B006Q7FC02
      B006PCE Protective Tape

      Put protective tape around the rear door belt moulding LH.

    2. B006M1BC02
      B006N8A Remove in this Direction

      Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claw from the interior as shown in the illustration.

    3. B006QH5

      Detach the guide and remove the rear door belt moulding LH.