FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT DOOR OUTER GLASS WEATHERSTRIP LH

   
   

   1. 

      Install in this Direction

      Install the front door glass outer weatherstrip LH as shown in the illustration.

   2. 

      Install in this Direction

      Attach the claw as shown in the illustration.

   3. 

      Attach the claw.

   4. Remove the protective tape.

2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

   Click here

3. INSTALL FRONT DOOR GLASS RUN LH

   Click here

4. INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH

   Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER LH

   Click here

6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

   Click here

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

8. INSTALL COURTESY LIGHT ASSEMBLY

   Click here

9. INSTALL FRONT ARMREST ASSEMBLY LH

   Click here

10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

11. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

13. INSTALL LOWER DOOR FRAME GARNISH LH

    Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

15. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

16. CHECK POWER WINDOW CONTROL SYSTEM

    Click here