FRONT BUMPER(for ALPHARD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart.

Click here

PROCEDURE


  1. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH


    1. A01IHGB

      Install the front wheel opening extension with the 3 screws.

  2. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL FRONT BUMPER SIDE SUPPORT LH


    1. A01IEPYC03
      B006N8A Install in this Direction

      Attach the claw to install the front bumper side support LH as shown in the illustration.

    2. Install the clip.

    3. Install the bolt.

  4. INSTALL FRONT BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    1. A01IJOS

      Install the front bumper reinforcement sub-assembly with the 8 bolts.

      Torque:
      66 N*m  { 673 kgf*cm, 49 ft.*lbf }

  6. INSTALL HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY


    1. A01IJU5

      Install the hood lock brace sub-assembly with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Attach the clamp.

  7. INSTALL THERMISTOR ASSEMBLY

    Click here

  8. INSTALL FRONT BUMPER ENERGY ABSORBER


    1. A01IF8UC01
      B006N8A Install in this Direction

      Install the front bumper energy absorber as shown in the illustration.

  9. INSTALL FRONT BUMPER COVER


    1. Attach the guide to install the front bumper cover.

    2. Connect the connector.

      A01IGKF
    3. A01IGQRC02
      B006N8A Install in this Direction

      Attach the claw as shown in the illustration.

    4. A01IJX7C02
      B006N8A Install in this Direction

      Attach the claw as shown in the illustration.

    5. Install the 3 clips and 2 bolts.

      A01IF4X

    6. Remove the protective tape.

    7. A01IIEW

      Install the 4 clips and 2 screws.

    8. A01IHPEC01
      *a CORRECT
      *b INCORRECT

      Install the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the pin hold clip on the other side.

    9. Install the clip.

      Tech Tips

      Use the same procedure for the clip on the other side.

  10. INSTALL RADIATOR GRILLE

    Click here

  11. INSTALL RADIATOR COVER SUB-ASSEMBLY

    Click here

  12. ADJUST FOG LIGHT AIMING


    1. for Bulb Type:

      Click here

    2. for LED Type:

      Click here

  13. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

    Click here