HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Check the rear height control sensor sub-assembly LH.


      1. Connect 3 dry batteries of 1.5 V in series.

      2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

        Note


        • Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

        • Do not apply a voltage of more than 6 V.

        A01IGGWC02
        *a

        Component without harness connected

        (Rear Height Control Sensor Sub-assembly LH)

        		 *b Low
        *c High *d Standard Position
        *e -30.7° *f +35.7°

      3. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Condition Specified Condition
        L4-1(SHG) - L4-2(SHRR) +35.7° (High) Approx. 4.5 V
        0° (Standard position) Approx. 2.25 V
        -30.7° (Low) Approx. 0.5 V

        If the result is not as specified, replace the rear height control sensor sub-assembly LH.