HEIGHT CONTROL SENSOR INSTALLATION

PROCEDURE


  1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Note

    If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.


    1. B006LXMC01
      *a Upper Side Bolt
      *b Lower Side Bolt

      Attach the hook.

    2. Temporarily install the rear height control sensor sub-assembly LH with the 3 bolts.

    3. Tighten the 3 bolts.

      Torque:
      Upper Side
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }
      Lower Side
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    4. Connect the connector.

  2. PERFORM INITIALIZATION

    Note

    If any of the work in the table below has been performed, vehicle information registration and initialization of the headlight light control ECU sub-assembly LH is necessary.

    Click here

    Performed Work or System Condition Necessary Procedures
    Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Initialization of the headlight light control ECU sub-assembly LH

  3. INSPECT AUTOMATIC LIGHT CONTROL SYSTEM

    Click here

  4. INSPECT HEADLIGHT AIMING

    Click here