HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly LH removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Initialization of the headlight light control ECU sub-assembly LH Automatic headlight beam level control system

Click here

PROCEDURE


  1. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B006LXM

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Detach the hook and remove the rear height control sensor sub-assembly LH.

      Note

      If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.