REAR LIGHT ASSEMBLY(for VELLFIRE) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE BACK DOOR CENTER GARNISH

    Click here

  2. REMOVE BACK DOOR SERVICE HOLE COVER LH

    Click here

  3. REMOVE BACK DOOR SIDE GARNISH LH

    Click here

  4. REMOVE BACK DOOR SIDE GARNISH RH

    Click here

  5. REMOVE BACK DOOR INSIDE HANDLE

    Click here

  6. REMOVE SWITCH BEZEL

    Click here

  7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  8. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

    Click here

  9. REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH

    Click here

  10. REMOVE REAR LIGHT ASSEMBLY LH

    Note

    If the rear light assembly LH has been removed, replace the rear light gasket with a new one.


    1. A01IFZG

      Disconnect the 2 connectors.

    2. Remove the 3 nuts.

    3. A01IJZVC01
      B006Q1Z Place hands here
      B006PCE Protective Tape

      Apply protective tape around the rear light assembly LH.

    4. Place your hand at the location shown in the illustration and pull the rear light assembly LH toward the rear of the vehicle to detach the clip and remove it.