REAR LIGHT ASSEMBLY(for ALPHARD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL REAR LIGHT ASSEMBLY LH


    1. B006QF2C01
      B006REL Back Window Moulding Outside
      B006PCE Protective Tape

      When installing the rear light assembly LH, secure the back door window moulding outside to the surface of the back door glass with protective tape so that the back door window moulding outside does not jam.

    2. B006N08C01
      B006PCE Protective Tape

      Attach the clip to install the rear light assembly LH.

    3. Install the 3 nuts.

    4. Connect the 2 connectors.

  2. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)

    Click here

  3. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

    Click here

  4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  5. INSTALL SWITCH BEZEL (w/ Power Back Door)

    Click here

  6. INSTALL BACK DOOR INSIDE HANDLE

    Click here

  7. INSTALL BACK DOOR SIDE GARNISH LH (w/o Power Back Door)

    Click here

  8. INSTALL BACK DOOR SIDE GARNISH LH (w/ Power Back Door)

    Click here

  9. INSTALL BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)

    Click here

  10. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

  11. INSTALL BACK DOOR CENTER GARNISH

    Click here