REAR LIGHT ASSEMBLY(for ALPHARD) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR LIGHT GASKET LH


    1. B006OR4

      Remove the rear light gasket LH.

      Note

      The rear light gasket LH cannot be reused.

  2. REMOVE REAR LIGHT LED


    1. B006N49

      Disconnect the connector.

    2. B006N1FC01
      B006N8A Counterclockwise

      Rotate the rear light LED counterclockwise until it stops, and then remove it.

  3. REMOVE REAR LIGHT SOCKET AND WIRE LH


    1. B006OG0

      Disconnect the connector.

    2. B006NHNC01
      B006PCE Protective Tape
      B006N8A Remove in this Direction

      Using a driver, detach the claw and remove the rear light socket and wire LH.

      Tech Tips

      Tape the screwdriver tip before use.