FOG LIGHT ASSEMBLY(for LED Type) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the fog light assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link

w/ Panoramic view monitor system:

Removal/installation of the front television camera assembly or the radiator grille

 Television camera view adjustment Panoramic view monitor system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    for ALPHARD:

    Click here

    for VELLFIRE:

    Click here

  2. REMOVE FOG LIGHT ASSEMBLY LH


    1. Disconnect the connector.

    2. Remove the 2 screws.

      B006NV7C01
      *A for ALPHARD *B for VELLFIRE

    3. Detach the guide and remove the fog light assembly LH.

      B006P18C01
      *A for ALPHARD *B for VELLFIRE