HEADLIGHT ASSEMBLY(for ALPHARD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight assembly LH removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Headlight assembly LH

  • Vehicle information registration for the headlight ECU sub-assembly LH

  • Initialization of the headlight ECU sub-assembly LH

 Automatic headlight beam level control system

Click here

w/ Panoramic view monitor system:

Removal/installation of the front television camera assembly or the radiator grille

 Television camera view adjustment Panoramic view monitor system

Click here

Note

Even if the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT ASSEMBLY LH


    1. B006OD9C01
      B006PCE Protective Tape

      Apply protective tape around the headlight assembly LH.

    2. Remove the 2 screws and bolt.

    3. B006PDMC01
      *a Connector Lock Lever

      Release the connector lock lever and disconnect the connector.

    4. B006Q0UC01
      *a Slide Rail
      B006Q1Z Place hand here
      B006NJK Pull Forward

      Place your hand at the location shown in the illustration, and disconnect the bracket from the seat of the screw.

      Note

      Be careful not to break the bracket.

    5. Pull the headlight assembly LH forward along the slide rail to detach the claw and remove the headlight assembly LH.