AUTOMATIC HIGH BEAM SYSTEM PROBLEM SYMPTOMS TABLE

Note

When replacing the combination meter assembly, make sure to replace it with a new one.

Tech Tips


  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

  • Camera detection malfunctions can be detected using the GTS.

  • Aiming misalignment of the camera can be detected using the GTS. If the camera aiming is misaligned, check the following conditions:


    • Check if the vehicle is inclined.

    • Check if the windshield glass is installed correctly.

    • Check if the inner rear view mirror assembly is installed correctly.

    • Check if there is deformation of the inner rear view mirror assembly.

  • If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.

  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Automatic High Beam System
Symptom Suspected Area Link
Inner rear view mirror assembly LED indicator does not illuminate. Inner rear view mirror assembly

Click here

Harness or connector -
Inner rear view mirror assembly LED indicator remains on even after operating the AUTO switch. Inner rear view mirror assembly

Click here

Automatic high beam indicator on the combination meter assembly does not illuminate. Check operating conditions Click here
Combination meter assembly

Click here

Main body ECU (Multiplex network body ECU)

Click here

Automatic high beam system does not operate. Check DTC

Click here

Check illumination condition of low and high beam headlights using manual operation

Click here

Check automatic light control

Click here

Check Data List Click here
Automatic high beam switch circuit

Click here

Harness or connector -
Inner rear view mirror assembly

Click here

Main body ECU (Multiplex network body ECU)

Click here

"To Activate Auto High Beam, Switch Headlights to High Beam" is displayed on the multi-information display. Check DTC

Click here

Main body ECU (Multiplex network body ECU)

Click here

Harness or connector -