LIGHTING SYSTEM PRECAUTION


  1. PRECAUTION FOR HEADLIGHT BULB REPLACEMENT


    1. If even a thin film of oil is left on the surface of a headlight bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand does not contact the glass part of the light.

    2. As the internal pressure of headlight bulbs is high, dropping, hitting or damaging a bulb may result in it exploding and shattering.

    3. Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.

    4. Always replace a bulb with another bulb of the same wattage.

    5. If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.

    6. Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may become filled with wate through gaps around the socket if the socket is not installed securely.

  2. PRECAUTION FOR HEADLIGHT BEAM AXIS ADJUSTMENT


    1. Do not use the cover for 3 minutes or more when the headlight is illuminated.

      The headlight outer lens is made of synthetic resin, which may melt or be damaged due to excessive heat.

  3. PRECAUTION FOR AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL


    1. Initialization is required when performing work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor LH, or replacement of suspension components, or when replacing the headlight light control ECU sub-assembly LH (main).