LIGHTING SYSTEM INITIALIZATION


  1. HEADLIGHT ECU SUB-ASSEMBLY LH INITIALIZATION

    Note


    • The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly LH removal/installation are shown below.

      Performed Work or System Condition Necessary Procedures Link
      Replacement of the headlight ECU sub-assembly LH Synchronize the vehicle information

      Click here

      Perform headlight ECU sub-assembly LH initialization
      Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed Perform headlight ECU sub-assembly LH initialization

    • A new headlight ECU sub-assembly LH cannot operate until the vehicle information is registered.

    • After replacing the headlight ECU sub-assembly LH, it is necessary to perform vehicle information registration and initialization.

    • Even if the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.