OUTER REAR VIEW MIRROR GLASS INSPECTION

PROCEDURE


  1. INSPECT OUTER MIRROR LH


    1. B006R8DC01
      *a

      Component without harness connected

      (Outer Mirror LH)

      w/ Mirror Heater:

      Check the outer mirror heater operation.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 7.1 to 9.5 Ω

        If the result is not as specified, replace the outer mirror LH.

    2. w/ Blind Spot Monitor System:

      Check the operation of the outer rear view mirror indicator.


      1. B006NS1C01
        *a

        Component without harness connected

        (Outer Mirror LH)

        Connect 4 new 1.5 V dry-cell batteries in series.

      2. Apply 6 V dry-cell batteries to the terminals of the connector, and check the blind spot monitor indicator condition.

        Note

        Do not apply a voltage of more than 6 V.

        OK
        Tester Connection Specified Condition

        6 V Battery Positive (+) → 2 (BSM+)

        6 V Battery Negative (-) → 1 (BSM-)

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror RH.

  2. INSPECT OUTER MIRROR RH


    1. B006MT9C01
      *a

      Component without harness connected

      (Outer Mirror RH)

      w/ Mirror Heater:

      Check the outer mirror heater operation.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 7.1 to 9.5 Ω

        If the result is not as specified, replace the outer mirror RH.

    2. w/ Blind Spot Monitor System:

      Check the operation of the outer rear view mirror indicator.


      1. Connect 4 new 1.5 V dry-cell batteries in series.

      2. B006LLWC02
        *a

        Component without harness connected

        (Outer Mirror RH)

        Apply 6 V dry-cell batteries to the terminals of the connector, and check the blind spot monitor indicator condition.

        Note

        Do not apply a voltage of more than 6 V.

        OK
        Tester Connection Specified Condition

        6 V Battery Positive (+) → 2 (BSM+)

        6 V Battery Negative (-) → 1 (BSM-)

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror RH.